Open Printer will use the Creative Commons BY-NC-SA 4.0 license for all of its files, including electronics and mechanical design files, firmware code, and the bill of materials.
Thanks I addressed that seconds ago https://lemmy.world/post/36926543/19781367 and my bet is that it’s an omission, so I asked on CS Discord just in case but yes people should be mindful of that before the crowd funding campaign start. Hopefully it’ll be fixed.
Isn’t it about documentation or design rather than code or hardware? Typically CC isn’t used for software or hardware.
from their own page
Thanks I addressed that seconds ago https://lemmy.world/post/36926543/19781367 and my bet is that it’s an omission, so I asked on CS Discord just in case but yes people should be mindful of that before the crowd funding campaign start. Hopefully it’ll be fixed.