Cisco Catalyst 2960-24TT-L

  • wallybeavis@lemmy.world
    link
    fedilink
    English
    arrow-up
    11
    ·
    edit-2
    11 months ago

    2007, excellent year! Also, I swear Cisco those older switches are will run forever (as long as you don’t reboot it too often 😂)

      • wallybeavis@lemmy.world
        link
        fedilink
        English
        arrow-up
        12
        ·
        11 months ago

        It’s an old joke, when a switch (or any electronics really) has 365+ day uptime rebooting could kill the power supply during its POST power supply test.

        Realistically you shouldn’t have to worry about it, those are solid switches. I have a 3524 from 2001 that’s still running, it gets bounced about once a year when I bump the power cable while recabling. I also have a 2960G that’s on a UPS, and without logging in I couldn’t tell you the uptime

    • nova@lemmy.blahaj.zone
      link
      fedilink
      arrow-up
      3
      ·
      11 months ago

      don’t update the firmware!!! these have a bug with their security module which essentially bricks them if you update past a certain point

      • u/lukmly013 💾 (lemmy.sdf.org)@lemmy.sdf.orgOP
        link
        fedilink
        English
        arrow-up
        2
        ·
        11 months ago

        Hmm. I planned to upgrade it to newest available IOS for this device, 15.0.2-SE11.
        What kind of bricking are we talking about here? (Permanent or fixable)

        I only found this:

        A Catalyst 2960 with 64Mb of DRAM might display Low memory on the console after upgrading to 12.2(58)SE or later

        Which should be fixed, and if not, I could just downgrade it back. Worst case scenario: I’ll have to use xmodem instead of TFTP.

        • nova@lemmy.blahaj.zone
          link
          fedilink
          arrow-up
          2
          ·
          11 months ago

          I can’t remember the exact message, basically when we upgraded about 10 of ours, they wouldn’t let us make any config changes past a certain point because they saw themselves as non genuine even though they are we’ve recently replaced all of our switching, I’ll boot one of them up once I get in and check for you (+IOS version)

          • wallybeavis@lemmy.world
            link
            fedilink
            English
            arrow-up
            2
            ·
            11 months ago

            Do you remember if you could get to a rommon prompt? As long as console access is available you should’ve been able to upload replacement FW. I once had to use kermit or xmodem (I don’t recall) @2400 bps to recover an AP by transferring new FW over the console cable (I’m not sure new APs even have a console port), but switches should be recoverable…the things you do, when you want to go home and not spend another day on site 🤣

            My only caution would be to ensure that you use the correct FW. IIRC -L means Lan Base not IP Services, but it should warn you that there isn’t enough space, if that’s the case